Free tool

Best DPI to scan old photos: calculator

For most old photos, 600 dpi is the best all-round setting: it lets you print a copy twice the original size at 300 pixels per inch, and it matches the 600 ppi that the U.S. federal digitization guidelines (FADGI) set for their top level for photo prints. 300 dpi is enough only to print the same size. Small prints you want to enlarge need more, often 1200 dpi. Enter your print below to see the setting, the pixel size and an approximate file size.

Your photo

What do you want to do with the scan?

Use your scanner's optical resolution, not an "interpolated" or "enhanced" figure, and turn off any upscaling. File sizes are approximate, calculated from the pixel count: TIFF is uncompressed, and JPEG depends on the photo and the quality setting. Runs in your browser; nothing is sent anywhere.

Add this scan dpi calculator to your site

Copy this code into your page. It shows the scan dpi calculator with a credit link to Relic.

Bring your old photos back. Add one old photo and get it back restored in full resolution, ready to print.

Restore my photo

Questions

Is 300 dpi good for scanning photos?

It's enough to print a copy at the same size at 300 pixels per inch. A 4 × 6 print scanned at 300 dpi is 1800 × 1200 pixels (2.2 MP). If you might print it larger or restore it later, scan at 600 dpi instead.

What dpi should I scan old photos at to enlarge them?

Multiply 300 by how many times larger you want the print. Twice as big needs 600 dpi, so a 4 × 6 print printed at 8 × 12 needs 600 dpi. A wallet print (2.5 × 3.5 in) printed at 8 × 10 needs about 960 dpi, so scan at 1200.

Can I enlarge an old photo without losing quality?

Only as far as the detail in the original print allows. A higher optical dpi captures more of that detail, but no setting adds detail the print doesn't have, and a soft print stays soft when it's enlarged. Interpolated dpi and upscaling add pixels, not detail.

Is a phone photo as good as a scan?

In pixels, a 12 MP phone photo that fills the frame matches about 670 dpi for a 4 × 6 print. In practice the lens, focus and glare give less real detail than a flatbed scan, so a scanner is the better choice for small prints you want to enlarge. For a big box of photos, a phone is faster: see our guide to scanning old photos with your phone.

Should I save scans as TIFF or JPEG?

Keep the master scan as TIFF if you have the space: it isn't compressed, so saving it again after edits doesn't lose detail. Save a JPEG copy for sharing. FADGI's top level for prints uses 16-bit TIFF or JPEG 2000 master files.

What can Relic do with the scan?

Relic repairs scratches, dust, cracks, fading, yellowing, tears and stains in one old photo in about 20 seconds and gives it back in full resolution, without a watermark. One photo is $1.99, one time. Check the result before you print it.

Sources

More from Relic

Updated October 29, 2026