Free tool

How to save water-damaged photos, step by step

Most water-damaged photos can be saved if you act within 48 hours, before mold can start to grow. Handle wet prints by the edges, rinse off dirt in clean water, and lay them face up on plain paper towels to air-dry, with no heat. Don't pull apart prints that are stuck together or stuck to glass, and don't put old card-mounted or cased photos in water. Pick what happened below for the steps from the National Park Service, Georgia Archives and National Archives guides.

Your photos

Steps are summarized from the National Park Service (NCPTT), Georgia Archives and National Archives guides listed under Sources; each step names its guide. This is general guidance, not a conservator's assessment. Runs in your browser; nothing is sent anywhere.

Add this water-damaged photo rescue to your site

Copy this code into your page. It shows the water-damaged photo rescue with a credit link to Relic.

Bring your old photos back. Add one old photo and get it back restored in full resolution, ready to print.

Restore my photo

Questions

Can water-damaged photos be repaired?

Often, yes. The Georgia Archives guide notes that photos are fragile when wet but can be dried, and stains can be reduced. Some warping and stains may remain, and some older photos are very sensitive to water and may not be recoverable. Once a print is dry, a scan of it can be repaired digitally without touching the original.

How do you separate photos stuck together by water?

While they are still wet, modern prints may come apart after soaking in cold water, according to the National Archives, but this can also damage them for good. Let them separate on their own and never pull. If the photos are valuable, or they have already dried together, the National Park Service guide says not to pull them apart and to ask a photo conservator.

How do I get a photo off the glass in a frame?

Act while it is still wet, because a print that dries onto glass usually can't be separated without damage. The guides differ here: Georgia Archives says to put the glass and print together in cold water (up to 48 hours for color, 72 for black and white) until the print comes free, while the National Archives says not to remove it and to dry it whole, glass side down. For anything you can't replace, ask a conservator first.

How do you dry wet photos?

Lay them face up on clean blotter paper, plain paper towels or a clean cloth, and change the paper underneath every hour or two. Dry them in the shade or in a room with a dehumidifier, with fans moving the air but not pointed straight at them. Don't use newspaper or printed towels, and don't stack prints face to face.

Can I use a hair dryer on wet photos?

None of the three guides on this page use heat. They all air-dry photos in moving room air, so a hair dryer, oven or heater isn't part of any of their methods.

Should I freeze wet photos?

If you can't dry modern prints within about 48 hours, Georgia Archives suggests rinsing them, stacking them between sheets of wax paper and freezing them in a zip-top bag, then thawing and air-drying later. Don't freeze old or valuable photos without asking a conservator, and never freeze glass negatives or glass positives.

What can Relic do after the photo is dry?

Relic works on a scan or a phone photo of the print, not the print itself. It repairs scratches, dust, cracks, fading, yellowing, tears and stains in one old photo in about 20 seconds and gives it back in full resolution, without a watermark. One photo is $1.99, one time. Check the result before you print it.

Sources

More from Relic

Updated October 29, 2026